Directions for Ribbon Extensions

Ribbon_Directions_1

TO INSTALL RIBBON EXTENSIONS:

Insert micro-link on to the threading needle. Section client’s hair. Grasp about 1/8” inch section of hair that is underneath client’s natural part. Insert sectioned hair through threading needle.

Ribbon_Directions_2

Slide micro-link off threading needle and on to hair.

Ribbon_Directions_3

Hold the micro-link close to the scalp, insert Ribbon Extension into the micro-link.

Ribbon_Directions_4

Be sure to position the hair and the micro-link so that it follows the flow of the hair. Do not hold in upward or sideways direction, which will cause uneven tension. Hold the hair and the micro-link into position. Crimp the micro-link flat. Be sure to crimp the micro-link tightly so it flattens out completely.

Ribbon_Directions_5

The ends of the Ribbons are specially treated to avoid fraying. Do not cut the ends of the Ribbons. If the Ribbon Extension is longer than the hair and you want to trim it, trim Ribbons from the top end only.

Ribbon_Directions_Removal

TO REMOVE: Insert the micro-link into the crimper. Crimp in opposite direction to open. Slide out the Ribbons from the micro-link. Discard the micro-link. You may choose to re-use the Ribbon Extension.